12 Volt Solar Panel Installation Instructions

SpinTech 12 Volt Solar Panel Assembly & Installation

Follow these step-by-step instructions to properly install your SpinTech 12 Volt Solar Panel to ensure optimal charging and performance.


1. Install the Angled Bracket (Top of Panel)

SpinTech 12 Volt Solar Panel Angeled Bracket

  • Using the smaller screws, attach the small angled bracket to the top of the solar panel.
  • Ensure the point of the angle is facing the back side of the solar panel.

💡 Identifying the Top of the Panel:
The pre-drilled mounting holes at the top are centered, while the bottom holes are positioned closer to the back of the panel


2. Install the Hinged Bracket (Bottom of Panel)

SpinTech 12 Volt Solar Panel Hinged Bracket

  • Use the remaining small screws to attach the hinged bracket to the bottom of the solar panel.
  • The rounded hinge should protrude away from the panel.

 

 

3. Run the Wiring Harness to the Feeder Battery

  • Route the solar panel wiring harness to the battery compartment of your feeder unit.

For SpinTech 12V Feeders:

  • Locate the pre-laser serrated hole on the back of the control unit (opposite the SpinTech sticker).
  • Pop out this hole to feed the solar panel wiring harness inside.

4. Mount the Solar Panel to Your Feeder

SpinTech 12 Volt Solar Panel Mounted to Feeder

4.1 For SpinTech 12V Feeders:

Your control unit has pre-pressed divots for easy mounting:

1️⃣ Top Mounting Points:

  • Just above the hole from Step 3, use the larger screws to secure the angled bracket at the top of the solar panel.

2️⃣ Bottom Mounting Points:

  • Near the bottom rear of the control unit, use the other large screws to secure the hinged bracket.
  • The solar panel will naturally align into the optimal position.


4.2 For Non-SpinTech Feeders:

  • Use the large self-tapping screws to mount the solar panel to the side of your hopper or another suitable location.
  • Placement is flexible based on your feeder setup.

5. Connect the Solar Panel to the Battery

  • Attach the solar panel clips to the battery terminals.
  • If piggybacking wires onto the battery, ensure the solar panel connects first before other wiring.

🔹 Wire Color Guide:

  • Brown = Positive (Red)
  • Blue = Negative (Black)

Need Assistance? We're Here to Help!

📞 Call Us: (210) 408-8019
📧 Email Us: info@spintechspreaders.com

Back to blog